Faculty Information - Daisuke Terada

Office

Works

（Last updated : 2025-03-24 13:43:00）

Daisuke Terada
Department of Advanced Materials Science and Engineering, Faculty of Engineering

Master's Program in Advanced Materials Science and Engineering, Graduate School of Engineering

Associate Professor

■ Office

Tsudanuma Campus, No.2 Building,7th floor room 010708

■ Works

1.	Article	Strengthening of A2024 alloy by high-pressure torsion and subsequent aging MATERIALS SCIENCE AND ENGINEERING A 704,pp.112-118 (Collaboration) 2017/09
2.	Article	Role of Different Kinds of Boundaries Against Cleavage Crack Propagation in Low-Temperature Embrittlement of Low-Carbon Martensitic Steel METALLURGICAL AND MATERIALS TRANSACTIONS A 48A(7),pp.3261-3268 (Collaboration) 2017/07
3.	Article	Concurrent strengthening of ultrafine-grained age-hardenable Al-Mg alloy by means of high-pressure torsion and spinodal decomposition ACTA MATERIALIA 131,pp.57-64 (Collaboration) 2017/06
4.	Article	Effect of strain rate on hydrogen embrittlement in low-carbon martensitic steel 42(5),pp.3371-3379 (Collaboration) 2017/02
5.	Article	Contactless electrical conductivity measurement of metallic submicron-grain material: Application to the study of aluminum with severe plastic deformation REVIEW OF SCIENTIFIC INSTRUMENTS 87(5),pp.053905 (Collaboration) 2016/01
6.	Article	Aging Behavior of Al 6061 Alloy Processed by High-Pressure Torsion and Subsequent Aging METALLURGICAL AND MATERIALS TRANSACTIONS A 46A(6),pp.2664-2673 (Collaboration) 2015/06
7.	Article	Recrystallization Behavior of CoCrCuFeNi High-Entropy Alloy METALLURGICAL AND MATERIALS TRANSACTIONS A 46A(4),pp.1481-1487 (Collaboration) 2015/04
8.	Article	Improvement of Uniform Elongation by Low Temperature Annealing in Al-2.5% Mg Alloy Processed by Accumulative Roll Bonding MATERIALS TRANSACTIONS 56(6),pp.803-807 (Collaboration) 2015
9.	Article	Enhanced Strength and Ductility in an Ultrafine-Grained Fe-22Mn-0.6C Austenitic Steel Having Fully Recrystallized Structure METALLURGICAL AND MATERIALS TRANSACTIONS A 45A(12),pp.5300-5304 (Collaboration) 2014/11
10.	Article	Optimizing strength and ductility in Cu-Al alloy with recrystallized nanostructures formed by simple cold rolling and annealing JOURNAL OF MATERIALS SCIENCE 49(19),pp.6629-6639 (Collaboration) 2014/10
11.	Article	Softening by severe plastic deformation and hardening by annealing of aluminum-zinc alloy: Significance of elemental and spinodal decompositions MATERIALS SCIENCE AND ENGINEERING A 610,pp.17-27 (Collaboration) 2014/06
12.	Article	Aging Behavior of Ultra-Fine Grained Al-0.5%Si-0.5%Ge Alloy Fabricated by ARB Process MATERIALS TRANSACTIONS 55(2),pp.249-254 (Collaboration) 2014/02
13.	Article	Mechanical Properties of Bulk Ultrafine Grained Aluminum Fabricated by Torsion Deformation at Various Temperatures and Strain Rates MATERIALS TRANSACTIONS 55,pp.106-103 (Collaboration) 2014/01
14.	Article	Stability of {4411} < 11 11 8 > Orientation in a {123} < 634 > Aluminum Single Crystal Processed by Accumulative Roll Bonding MATERIALS TRANSACTIONS 55(11),pp.1656-1661 (Collaboration) 2014
15.	Article	Methods for Designing Concurrently Strengthened Severely Deformed Age-Hardenable Aluminum Alloys by Ultrafine-Grained and Precipitation Hardenings METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE 44A(8),pp.3921-3933 (Collaboration) 2013/08
16.	Article	Flow Stress Analysis for Determining Critical Condition of Dynamic Ferrite Transformation in 6Ni-0.1C Steel Acta Mater. 61,pp.163-173 (Collaboration) 2013
17.	Article	I Recrystallization Texture of Heavily Cold Rolled Polycrystalline Nickel Sheets with and without Strong Starting Cube Texture Mater. Sci. Forum 753,pp.293-296 (Collaboration) 2013
18.	Article	Identical Area Observations of Deformation-induced Martensitic Transformation in SUS304 Austenitic Stainless Steel Mater. Trans. 54,pp.308-313 (Collaboration) 2013
19.	Article	Microstructures of Pearlite and Martensite Transformed from Ultrafine-Grained Austenite Fabricated through Cyclic Heat Treatment in Medium Carbon Steels Mater. Trans. 54,pp.1570-1574 (Collaboration) 2013
20.	Article	Texture Evolution in {112}<111> Aluminum Single Crystals Processed by Severe Plastic Deformation Mater. Charac. 75,pp.129-137 (Collaboration) 2013
21.	Article	Characterization of Defects in Severely Deformed Iron by Mechanical Spectroscopy Solid State Phenomena 184,pp.233-238 (Collaboration) 2012
22.	Article	Crystallographic Features of Martensite Transformed from Ultrafine Grained Austenite Fabricated by Severe Plastic Deformation Mater. Sci. Forum 706-709,pp.1835-1840 (Collaboration) 2012
23.	Article	Effect of SiC Particles on Microstructure Evolution in Aluminum during Severe Plastic Deformation by ARB Process Mater. Sci. Eng. A 540,pp.13-23 (Collaboration) 2012
24.	Article	Evolution of Microstructure and Texture during Cold Rolling and Annealing of a Highly Cube Textured ({001}<100>) Polycrystalline Nickel Sheet Metall. Mater. Trans. A 43,pp.2442-2452 (Collaboration) 2012
25.	Article	Microstructural Evolution during ARB Process of Al-0.2mass%Sc Alloy Containing Al3Sc Precipitates in Starting Structures Mater. Trans. 53,pp.72-80 (Collaboration) 2012
26.	Article	Nanostructure Evolution in Commercial Purity Aluminium Heavily Deformed by Torsion J. Mater. Sci. (UFG VII) 47,pp.7841-7847 (Collaboration) 2012
27.	Article	Stability of Cube Oriented Grains during Cold-Rolling of Highly Cube-Oriented Polycrystalline Nickel Mater. Sci. Forum 702-703,pp.402-405 (Collaboration) 2012
28.	Article	Annealing Behavior of Solution Treated and Aged Al-0.2wt%Sc Deformed by ARB Mater. Sci. Forum 667-669,pp.211-216 (Collaboration) 2011
29.	Article	Change in Crystal Orientation of a {100}<001> Pure Aluminum Single Crystal during Accumulative Roll Bonding Mater. Treans. 52,pp.825-829 (Collaboration) 2011
30.	Article	Effect of Aging Treatment on Ultrafine Grains and Si-Phase in Al-0.5%Si Alloy Fabricated by ARB Process Mater. Trans. 52,pp.1853-1859 (Collaboration) 2011
31.	Article	Formability of ultrafine-grained interstitial-free steel fabricated by accumulative roll-bonding and subsequent annealing Scripta Materialia 65,pp.175-178 (Collaboration) 2011
32.	Article	High-Temperature Severe Plastic Deformation of Ferritic Steel by Torsion Mater. Sci. Forum 667-669,pp.403-408 (Collaboration) 2011
33.	Article	Martensite/Austenite Interfaces in Ultrafine Grained Fe-Ni-C Alloys J. Mater. Sci. 46,pp.4216-4220 (Collaboration) 2011
34.	Article	Martensite/austenite interfaces in ultrafine grained Fe-Ni-C-alloy Journal of Material Science 46,pp.4216-4220 (Collaboration) 2011
35.	Article	Martensitic Transformation from Ultrafine Grained Austenite Fabricated by ARB in Fe-24Ni-0.3C Mater. Sci. Forum 667-669,pp.361-366 (Collaboration) 2011
36.	Article	Mechanical Properties of Precipitation Strengthening Cu-base Alloys Highly Deformed by ARB Process Procedia Engineering 10,pp.2417-2422 (Collaboration) 2011
37.	Article	Synthesis of non-equilibrium phases in immiscible metals mechanically mixed by high pressure torsion J. Mater. Sci. 46,pp.4296-4301 (Collaboration) 2011
38.	Article	Analysis of deformation behaviors of ultrafine grained Cu-30%Zn with bimodal grain-size distribution J. of Physics: Conference Series 240,pp.012015 (Collaboration) 2010
39.	Article	Effect of Grain Size Distribution on Mechanical Properties of Ultrafine Grained Al Severely Deformed by ARB Process and Subsequently Annealed J. of Physics: Conference Series 240,pp.012111 (Collaboration) 2010
40.	Article	Strain hardening and softening in ultrafine grained Al fabricated by ARB process J. of Physics: Conference Series 240,pp.012114 (Collaboration) 2010
41.	Article	Susceptibility to Hydrogen Embrittlement of IF Steel with Ultrafine-Grained Structure Produced by Accumulative Roll-Bonding Process Mater. Sci. Forum 654-656,pp.1235-1238 (Collaboration) 2010
42.	Article	Anodic oxide nanotube layers on Ti-Ta alloys: Substrate composition, microstructure and self-organization on two-size scales CORROSION SCIENCE 51,pp.1528-1533 (Collaboration) 2009
43.	Article	Compressive and tensile properties of CuZrAl alloy plates containing martensitic phases Materials Sci. and Eng. A 517,pp.375-380 (Collaboration) 2009
44.	Article	Hot Deformation and Dynamic Recrystallization Behaviour of Medium Carbon Steel in Austenite Region Steel Research International 80,pp.627-631 (Collaboration) 2009
45.	Article	Metallurgical aspects on the formation of self-organized anodic oxide nanotube layers Electrochemica Acta 54,pp.5155-5162 (Collaboration) 2009
46.	Article	Microstructure Homogeneity and Mechanical Properties of Electrodeposited Nanocrystalline Ni J. of Physics: Conference Series 165,pp.012003 (Collaboration) 2009
47.	Article	Structure Change and Improvement of the Mechanical Properties of Lotus-type Porous Copper by Wire-brushing J. of Physics: Conference Series 165,pp.012070 (Collaboration) 2009
48.	Article	Change in Mechanical Properties and Microstructure of ARB processed Ti during Annealing Mater. Trans. 49,pp.41-46 (Collaboration) 2008
49.	Article	Effect of strain on "hardening by annealing and softening by deformation" phenomena in ultra-fine grained aluminum Journal of Material Science 23-24,pp.7331-7337 (Collaboration) 2008
50.	Article	Managing both strength and ductility in ultrafine grained steels ISIJ International 48,pp.1114-112 (Collaboration) 2008
51.	Article	Microstructure and Aging Behavior of Al-0.2wt%Zr Alloy Heavily Deformed by ARB Process Mater. Sci. Forum 584-586,pp.728-733 (Collaboration) 2008
52.	Article	Microstructure and Mechanical Properties of Al-0.5at.%X (=Si, Ag, Mg) Alloys Highly Deformed by ARB Process Mater. Sci. Forum 584-586,pp.547-552 (Collaboration) 2008
53.	Article	Microstructure quantification and correlation with flow stress of ultrafine grained commercially pure Al fabricated by equal channel angular pressing (ECAP) Materials Characterization 59,pp.1312-1323 (Collaboration) 2008
54.	Article	Tensile properties and twinning behavior of high manganese austenitic steel with fine-grained structure Scripta Mater 59,pp.963-966 (Collaboration) 2008
55.	Article	Evolution of Microstructure and Texture of Pure Al Single Crystal Having {112}<110> Orientation during Severe Plastic Deformation Adv. Mater. Res. 26-28,pp.405-408 (Collaboration) 2007
56.	Article	Improving NO2 sensitivity by adding WO3 during processing of NiO sensing-electrode of mixed-potential-type zirconia-based sensor Journal of The Electrochemical Society 154,pp.J246-J252 (Collaboration) 2007
57.	Article	Low Temperature Recrystallization of High Purity Iron Severely Deformed by ARB Process Mater. Sci. Forum 558-559,pp.357-362 (Collaboration) 2007
58.	Article	Microstructure and Mechanical Properties of Commercial Purity Titanium Severely Deformed by ARB Process Journal of Materials Science 47,pp.1673-1681 (Collaboration) 2007
59.	Article	Mixed-potential-type zirconia-based NOx sensor using Rh-loaded NiO sensing electrode operating at high temperatures Solid State Ionics 177,pp.2305-2311 (Collaboration) 2006
60.	Article	Sensing Characteristics of YSZ-based Mixed-potential-type Planar NOx Sensors Using NiO Sensing-electrodes Sintered at Different Temperatures J. Electrochem. Soc. 152,pp.H95-H101 (Collaboration) 2005
61.	Article	In-situ Observation of Dislocation Motion and Its Mobility in Fe-Mo and Fe-W Solid Solution at High Temperature ISIJ International 42,pp.1546-1552 (Collaboration) 2002
Display 5 items
Display all(61)